Once you've registered your edge gateway to the IXON Cloud and connected your FANUC to one of the LAN ports, you're ready to remotely access it.

If you've already followed the steps in this article and are unable to connect, see instead Can't connect to your machine - Issues and solutions.

1. LAN Source NAT needs to be disabled. It's on by default in the edge gateway's settings, but needs to be disabled for you to connect to your FANUC.
   • Check your FANUC's network settings first and make sure that the edge gateway's LAN IP address is entered as the FANUC's default gateway.
   • Once that is done, turn off LAN Source NAT in the edge gateway settings at Fleet Manager > Devices > Click on your device name  > Network > LAN.
2. Set up a VPN connection to your edge gateway.

You can now use your (development) software to connect to your FANUC.

3. Connect to your FANUC as you normally do.

If you are unable to connect, see Can't connect to your machine - Issues and solutions.